[an error occurred while processing this directive]
Skip to Main Content

Latest News

Advertisement
Advertise Here
September 14, 2010

Synthetic Skin Gets A Soft Touch

Materials Science: Pressure sensors give artificial skin a sense of touch

Celia Henry Arnaud

  • Print this article
  • Email the editor

Latest News



October 28, 2011

Speedy Homemade-Explosive Detector

Forensic Chemistry: A new method could increase the number of explosives detected by airport screeners.

Solar Panel Makers Cry Foul

Trade: U.S. companies complain of market dumping by China.

Novartis To Cut 2,000 Jobs

Layoffs follow similar moves by Amgen, AstraZeneca.

Nations Break Impasse On Waste

Environment: Ban to halt export of hazardous waste to developing world.

New Leader For Lawrence Livermore

Penrose (Parney) Albright will direct DOE national lab.

Hair Reveals Source Of People's Exposure To Mercury

Toxic Exposure: Mercury isotopes in human hair illuminate dietary and industrial sources.

Why The Long Fat?

Cancer Biochemistry: Mass spectrometry follows the metabolism of very long fatty acids in cancer cells.

Text Size A A

SOFT LANDING Pressure sensors for artificial skin can detect even a butterfly on their surface. Linda Cicero/Stanford News Service
SOFT LANDING Pressure sensors for artificial skin can detect even a butterfly on their surface.

Electronic skin that can mimic the human sense of touch is a step closer to reality. Such artificial skin could be used to give robots or prosthetic limbs a sense of touch. Two groups now independently report sensitive, flexible pressure sensors that can be incorporated into large-scale skinlike materials.

Zhenan Bao and coworkers at Stanford University make highly sensitive, flexible pressure sensors by sandwiching microstructured polydimethylsiloxane films between arrays of flexible electrodes (Nat. Mater., DOI: 10.1038/nmat2834). Air gaps between the microstructures lead to changes in device capacitance when applied pressure pushes the air out. These capacitance changes correspond to the applied pressure.

The sensors are sensitive enough to detect even a tiny insect on the surface, which exerts a pressure of only a few pascals, but they also respond to pressures as high as 15 kPa. The gentlest human touch exerts about 1 kPa.

The devices use pyramidal microstructures, but other shapes are also possible. "Using a variety of structures, we can tune the sensitivity range and the load that the pressure sensors can experience," Bao says. "By incorporating all of them in a sensor array, we can make sensors that function over a broad range, just like our skin."

In other work, Ali Javey and coworkers at the University of California, Berkeley, demonstrate that nanowire arrays can work as the circuitry needed for low-voltage macroscale artificial skin (Nat. Mater., DOI: 10.1038/nmat2835). The nanowire circuits can be operated at lower voltages than are needed for the organic transistors usually found in flexible electronics, Javey says.

SENSOR ARRAY An optical image of an electronic skin device with nanowire active-matrix circuitry. The device is 7 × 7 cm<sup>2</sup> with 18 × 19 pixels. Ali Javey & Kuniharu Takei
SENSOR ARRAY An optical image of an electronic skin device with nanowire active-matrix circuitry. The device is 7 × 7 cm2 with 18 × 19 pixels.

The Berkeley team makes the arrays by transferring nanowires grown on a silicon substrate to a flexible "receiver" substrate. The simplest way to achieve the transfer is by contact printing—growing the nanowires on a cylindrical drum and then rolling the drum across the receiver substrate. "The nanowires get aligned and transferred to the receiver substrate by this simple process," Javey says. "You get parallel arrays of printed nanowires."

So far, they've made devices that are 7 × 7 cm2 with an 18 × 19 pixel array. "Ultimately, we want to make it as big as possible, so we can cover the entire body of a robot," Javey says. "Right now, we’re limited by the size of the processing tools we have in an academic lab."

"These groups are at the forefront of a new and exciting field of research into biointegrated electronics," says John A. Rogers, a materials scientist at the University of Illinois, Urbana-Champaign, who works with flexible electronics. "The work is exceptional for its focus, not only on materials or individual devices, but on full system-level demonstrations with impressive levels of function."

Chemical & Engineering News
ISSN 0009-2347
Copyright © 2011 American Chemical Society
  • Print this article
  • Email the editor

Services & Tools

ACS Resources

ACS is the leading employment source for recruiting scientific professionals. ACS Careers and C&EN Classifieds provide employers direct access to scientific talent both in print and online. Jobseekers | Employers

» Join ACS

Join more than 161,000 professionals in the chemical sciences world-wide, as a member of the American Chemical Society.
» Join Now!